[j-nsp] Logical-Systems serie M and MX

[Gabriel Farias]

Thanks, I'll use the suggestion Mohan, established neighborhoods EBGP
between Ls1 and LS2 to LS3

Gabriel.

2010/5/29 Alan Gravett <alangra at gmail.com>

> Gabriel,
>
> You cannot copy routes between Logical Systems, as there is a separate RPD
> instance
> for each LS. (unlike VRs where rib-groups etc can be used)
>
> If you have tunnel capabilities in the chassis (check for presence of lt-*
> interface) you can interconnect LS's in this way.
>
> Alan
>
>
> On Fri, May 28, 2010 at 10:24 PM, Gabriel Farias <
> gabrielfarias03 at gmail.com> wrote:
>
>> Thanks this would be the only option?
>>
>> Best regard,
>> Gabriel Farias
>>
>>
>>
>> 2010/5/28 Mohan Nanduri <mohan.nanduri at gmail.com>
>>
>> > you can configure bgp session between the logical systems, as they are
>> like
>> > a true separate router.
>> >
>> > On Fri, May 28, 2010 at 3:27 PM, Gabriel Farias <
>> gabrielfarias03 at gmail.com
>> > > wrote:
>> >
>> >> Hello Gentlemen,
>> >>
>> >>
>> >> I have a chassis M10i (Junos 9.6R1.13) with three-logical systems (LS1,
>> >> LS2
>> >> and LS3) configured and running, need to copy the routing tables of the
>> >> LS1
>> >> and LS2 to LS3, I have some questions:
>> >>
>> >>
>> >>
>> >> 1)      Can I copy this?
>> >>
>> >> 2)      How best to do if possible?
>> >>
>> >>
>> >> Done in consultation with J-net and also in part of Juniper support
>> site
>> >> and
>> >> found much documentation, but nothing talking about this specific
>> issue.
>> >>
>> >> Thanks,
>> >> Gabriel Farias
>> >> _______________________________________________
>> >> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> >> https://puck.nether.net/mailman/listinfo/juniper-nsp
>> >>
>> >
>> >
>> _______________________________________________
>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>
>
>