[j-nsp] ERX310 PPPoE and multiple Virtual-routers
Hendrik Kahmann
hendrik.kahmann at ewetel.de
Tue Nov 2 14:15:10 EDT 2010
There should be a loopback with a valid ipv4/ipv6 address. This address is used as unnumbered source for _any_ created pppoe subinterface.
Kimd regards,
Hendrik
Am 02.11.2010 um 18:52 schrieb Tom Teeuwen <tom at tomteeuwen.eu>:
> Hello Hendrik,
>
> Thnx, it works !!
>
> The local-interface loopback, the IP-adres.. .does it matters ?
>
> Kind regards,
> Tom
>
>
>
> ________________________________________
> Van: juniper-nsp-bounces at puck.nether.net [juniper-nsp-bounces at puck.nether.net] namens Hendrik Kahmann [hendrik.kahmann at ewetel.de]
> Verzonden: dinsdag 2 november 2010 8:07
> Aan: Diogo Montagner; juniper-nsp at puck.nether.net
> Onderwerp: Re: [j-nsp] ERX310 PPPoE and multiple Virtual-routers
>
> Hello,
>
> as far as i know, this might be your solution:
>
> aaa domain-map "ABC"
> router-name "ABC"
> local-interface loopback 101
> ipv6-router-name default
> strip-domain enable
> !
> aaa domain-map "DEF"
> router-name "DEF"
> local-interface loopback 102
> ipv6-router-name default
> strip-domain enable
> !
> profile pppoe-defaults
> ip mtu 1492
> ip sa-validate
> ip tcp adjust-mss 1400
> ppp authentication pap
> !
> interface gigabitEthernet 1/0.10
> vlan id 10
> pppoe
> pppoe auto-configure
> pppoe remote-circuit-id
> pppoe profile any pppoe-defaults
> !
> interface gigabitEthernet 1/0.20
> vlan id 20
> pppoe
> pppoe auto-configure
> pppoe remote-circuit-id
> pppoe profile any pppoe-defaults
> !
>
> Users would be john at ABC or jim at DEF
>
>
> Kind regards,
>
> Hendrik
>
>
> Am 02.11.2010 05:23, schrieb Diogo Montagner:
>> AFAIK, you need different subinterfaces for each virtual-router.
>>
>> Eg.:
>>
>> Vlan 10 - VR ABC
>> Vlan 20 - VR DEF
>> ...
>>
>> Rgs
>>
>> On 11/2/10, Tom Teeuwen<tom at tomteeuwen.eu> wrote:
>>> Hello,
>>>
>>>
>>>
>>> I'm configuring an ERX310 for PPPoE termination.
>>>
>>> From the all DSLAM's we get about 190 tagged VLAN's.
>>>
>>> So for every VLAN i need to create a subinterface.
>>>
>>>
>>>
>>> Now we want to create multiple virtual-routers for customers who want to get
>>> an VPN.
>>>
>>> In the basic setup without VR's(only the default) i have a profile bounded
>>> to an subinterface.
>>>
>>> The profile config:
>>>
>>> profile Test
>>> ip unnumbered gigabitEthernet 1/1.102
>>> ppp authentication virtual-router default pap
>>>
>>>
>>>
>>> Now I created a VR and a domain-map and mapped a domain to the VR
>>>
>>> But the PPPoE request is comming from the same subinterface as above
>>> specified (where i attached a profile to the subinterface)
>>>
>>> Problem is that I only can attach one profile to a subinterface.
>>>
>>> I want the following:
>>>
>>> - based on a domain attach the PPPoE session to a specific VR
>>>
>>> - PPPoE request can come from different subinterfaces
>>>
>>>
>>>
>>> Example:
>>>
>>> Customer 1 form subif 1 to VR-A
>>>
>>> Customer 2 from subif 1 to VR-B
>>>
>>> Customer 3 from subif 2 to VR-A
>>>
>>> Customer 4 from subif 2 to VR-B
>>>
>>>
>>>
>>> Kind regards,
>>>
>>> Tom
>>> _______________________________________________
>>> juniper-nsp mailing list juniper-nsp at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/juniper-nsp
>>>
>
>
> --
> Hendrik Kahmann
> B.Sc. Wirtschaftsinformatik
>
> Planung - Technische Produktentwicklung
> Telefon: +49 441 8000 2778
>
> mailto:hendrik.kahmann at ewetel.de
>
> ___________________________________________
>
> EWE TEL GmbH
> Cloppenburger Straße 310
> 26133 Oldenburg
>
> Handelsregister Amtsgericht Oldenburg HRB 3723
> Vorsitzender des Aufsichtsrates: Dr. Werner Brinker
> Geschäftsführung: Hans-Joachim Iken (Vorsitzender),
> Ulf Heggenberger, Dr. Norbert Schulz, Dirk Thole
>
> Homepage: http://www.ewetel.de
>
> ___________________________________________
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>
More information about the juniper-nsp
mailing list