[j-nsp] ERX route distribution via RIP

[Tom Teeuwen]

Found a solution:
On my loopback interface i used for the pppoe i had to enter the following command:
ip rip copy-to-dynamic

Kind regards,
Tom



________________________________________
Van: Tom Teeuwen
Verzonden: zaterdag 6 november 2010 17:03
Aan: juniper-nsp-bounces at puck.nether.net
Onderwerp: RE: ERX route distribution via RIP

My logging shows the following:

DEBUG 11/06/2010 11:01:38 ripRoute (myvirtualrouter): can't receive, circuit not
found

Someone an idee what it is ?
________________________________________
Van: juniper-nsp-bounces at puck.nether.net [juniper-nsp-bounces at puck.nether.net] namens Tom Teeuwen [tom at tomteeuwen.eu]
Verzonden: vrijdag 5 november 2010 9:18
Aan: juniper-nsp at puck.nether.net
Onderwerp: [j-nsp] ERX route distribution via RIP

Hello,

I would like to distribute routes from my CPE (Cisco 877) to my ERX. CPE's are connectec via PPP.
On the CPE i configured:
router rip
 version 2
  network 10.0.0.0
  no auto-summary
Config says network 10.0.0.0 but because I used no auto-summary it sends 10.64.63.0

On my ERX I configured:
router rip
 version 2
 address 10.32.3.254
The address is the adress from the loopback interface used for the ppp

10.32.3.254, Rip is up, loopback209
  Send version = 2
  Receive version = 2
  Authentication mode = none
  Default metric = 1
  Passive Interface = No
  Access-list applied to outgoing route = none
  Access-list applied to incoming route = none
  Route-map applied to outgoing route = none
  Received bad packet = 0
  Received bad routes = 0
  Triggered updates sent = 0
  Received updates = 0
--------------------------------------------------------------------
I'm not receiving the routes, also tried with neighborh statement.


Kind regards,
Tom
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp