[j-nsp] Chassis Cluster - Strange behavior

Fahad Khan fahad.khan at gmail.com
Sat Sep 18 02:41:56 EDT 2010


Yes I can understand, But i need to use the cluster and intend to add the
secondary device again to the cluster. I hope it will set to the configured
priorities after connecting both devices in the cluster as cold sync or
flowd runs at the time of reboot to syc SPUs.

regards,

Muhammad Fahad Khan
JNCIP - M/T # 834
IT Specialist
Global Technology Services, IBM
fahad at pk.ibm.com
+92-301-8247638
Skype: fahad-ibm
http://pk.linkedin.com/in/muhammadfahadkhan


On Sat, Sep 18, 2010 at 5:14 AM, Harshit Kumar <harshit at juniper.net> wrote:

> On a single node cluster, priority has no significance. You
> can safely ignore this. You can move to stand-alone mode if
> you don't plan to use the cluster.
>
>
> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net [mailto:
> juniper-nsp-bounces at puck.nether.net] On Behalf Of Fahad Khan
> Sent: Friday, September 17, 2010 8:05 AM
> To: juniper-nsp at puck.nether.net
> Subject: [j-nsp] Chassis Cluster - Strange behavior
>
> Hi Folks,
>
> I have been running SRX3600 In chassis cluster.
>
> At the moment, I have disconnected control link and fabric link and
> Secondary device is isolated from the network. But on primary device, the
> cluster configs are still there. The network is working fine with primary
> device but when i see chassis cluster status, i find this
>
> SRX3600-A> show chassis cluster status
> Cluster ID: 1
> Node                  Priority          Status    Preempt  Manual failover
>
> Redundancy group: 0 , Failover count: 1
>    node0                   254         primary        no       no
>    node1                   0           lost           n/a      n/a
>
> Redundancy group: 1 , Failover count: 1
>    node0                   0           primary        yes      no
>    node1                   0           lost           n/a      n/a
>
> why I am getting Node0 priority as 0 for red group 1, while i has been set
> to 254???
>
> have any body experienced?????
>
> thanks and regards,
>
>
> Muhammad Fahad Khan
> JNCIP - M/T # 834
> IT Specialist
> Global Technology Services, IBM
> fahad at pk.ibm.com
> +92-301-8247638
> Skype: fahad-ibm
> http://pk.linkedin.com/in/muhammadfahadkhan
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>


More information about the juniper-nsp mailing list