[j-nsp] Arp entries not showing on IRB interfaces.

[Peter Krupl]

Hi,


I just figured it out....

The arp entry is created for the LSI interface or the local ports participating in a bridging or vpls instance. And not the BVI interface.

Quite counter intuitive in my opinion..... 

Kind regards,
Peter Krupl


> -----Original Message-----
> From: Hentati, Akram [mailto:ahentati at upcbroadband.com]
> Sent: 06. May, 2011 16:10
> To: Peter Krupl
> Subject: RE: Arp entries not showing on IRB interfaces.
> 
> Hi Peter,
> 
> Which command are u using?
> 
> Cheers,
> Akram
> 
> 
> 
> 
> -----Original Message-----
> From: juniper-nsp-bounces at puck.nether.net [mailto:juniper-nsp-
> bounces at puck.nether.net] On Behalf Of Peter Krupl
> Sent: 06 May 2011 11:23
> To: 'juniper-nsp List'
> Subject: [j-nsp] Arp entries not showing on IRB interfaces.
> 
> Hi,
> 
> I could not find anything obvious in the KB. But it seems like IRB interfaces arp
> entries cannot be displayed.
> This applies to MX80 10.4R3.4, and MX240(DPC) 10.2R1.8.
> 
> This applies to both
> set bridge-domains b101 routing-interface irb.96 and set routing-instances e101
> instance-type vpls set routing-instances e101 routing-interface irb.101
> 
> Is this something that has been previously observed by anyone ?
> Everything seems to be working just fine.
> 
> 
> Kind regards,
> Peter Krüpl
> 
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp