[j-nsp] config help

[Richard Zheng]

Hi,

Here is our setup. Customer A comes in on vlan 2001, customer B on vlan 2002
and etc. We may uses separate subnets for each vlan. However it wastes lots
of IPs. Is there a way to use the same subnet, e.g. vlan 2001 uses IP
10.0.0.10, and vlan 2002 uses IP 10.0.0.11 and 10.0.0.12. How about use
10.0.0.1/24 as loopback, enable proxy-arp on each vlan, then put a filter on
each interface to only allow assigned IP to go through?

Would this work on M7i/M10i?

Thanks,
Richard