[j-nsp] TCPDUMP on High-end SRX

Tim Eberhard xmin0s at gmail.com
Tue Dec 11 13:27:40 EST 2012


That will *only* grab traffic to the control plane, not through the
interfaces. For what its worth.

-Tim Eberhard

On Tue, Dec 11, 2012 at 12:24 PM, 叶雨飞 <sunyucong at gmail.com> wrote:

> monitor traffic no-resolve interface xxxxx write-file xxx.pcap
>
> or, if you prefer, simply start shell then tcpdump -i xxx -n -p -w
> xxxx.pcap
>
> On Tue, Dec 11, 2012 at 9:00 AM, mahmoud yasin <eng_mahmood48 at yahoo.com>
> wrote:
> > Hi
> >
> > How to use TCPDump to capture the In/Out traffic from the firewall
> interface (device self generated traffic).
> > Also how to read the output using wireshark (how to get a copy of the
> file)?
> > This is required for High-end firewalls.
> >
> > Regards
> > Myasin
> > _______________________________________________
> > juniper-nsp mailing list juniper-nsp at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/juniper-nsp
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>


More information about the juniper-nsp mailing list