[j-nsp] MX960 Redundant RE problem

[Serge Vautour]

You can also run the following command on the backup RE to check it's state:

me at BLAH-re1> show system switchover 
Graceful switchover: On
Configuration database: Ready
Kernel database: Ready
Peer state: Steady State


If this command and "show task replication" on the master RE don't show the correct outputs, I agree with the recommendation to turn GRES/NSR on/off. If that doesn't work, reboot REs.


Serge



________________________________
 From: Mohammad <masalbad at gmail.com>
To: juniper-nsp at puck.nether.net 
Sent: Wednesday, February 15, 2012 6:44:42 AM
Subject: Re: [j-nsp] MX960 Redundant RE problem
 
Kindly find the following output, I hope it is helpful
xxxxx> show task replication 
        Stateful Replication: Enabled
        RE mode: Master

    Protocol                Synchronization Status
    OSPF                    Complete              
    BGP                     Complete              
    IS-IS                   Complete              
    MPLS                    Complete              
    RSVP                    Complete              

{master}
xxxx>


_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp