[j-nsp] Interface to be used for Trunking & MPLS
Caillin Bathern
caillinb at commtelns.com
Thu May 17 21:14:26 EDT 2012
Try using encapsulation flexible-ethernet-services on the CE facing
interface.
-----Original Message-----
From: juniper-nsp-bounces at puck.nether.net
[mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Saba Sumsam
Sent: Friday, 18 May 2012 9:29 AM
To: juniper-nsp at puck.nether.net
Subject: [j-nsp] Interface to be used for Trunking & MPLS
Hi,
I have an MX-80 acting as a PE router, where ge-1/1/1 is the CE-facing
interface which is connected to the trunk port of a switch. The
configuration looks like this:
[edit interfaces ge-1/1/1]
flexible-vlan-tagging;
encapsulation vlan-ccc;
unit 0 {
encapsulation vlan-ccc;
vlan-id-range 700-800;
family ccc;
}
[edit protocols]
connections remote-interface-switch VLAN700-800 interface ge-1/1/1.0
connections remote-interface-switch VLAN700-800 transmit-lsp LSP_MX
connections remote-interface-switch VLAN700-800 receive-lsp LSP_EX
VLAN range 700-800 is being transported across MPLS to the remote PE
device. The same interface, ge-1/1/1 is also receiving VLAN400 (through
the
trunk) but should not be sent via MPLS but to another switch connected
to the MX-80. I tried the following configuration on the same interface:
[edit interfaces ge-1/1/1]
unit 400 {
family bridge {
interface-mode trunk;
vlan-id-list 400;
'unit 400'
Link encapsulation type is not valid for device type
error: configuration check-out failed
Any suggestions how to make this work? The same physical interface
should be able to send specific VLANs out over MPLS and others out any
other interfaces.
Regards.
*Saba Sumsam*
*Network Engineer - Level 2*
eintellego Pty Ltd
saba at eintellego.net <ali at eintellego.net> ; www.eintellego.net
Phone: 1300 753 383 ; Fax: (+612) 8572 9954
Cell +61 (0)424753773
facebook.com/eintellego
PO Box 7726, Baulkham Hills, NSW 1755 Australia
The Experts Who The Experts Call
Juniper - Cisco - Brocade - IBM
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
--
Message protected by MailGuard: e-mail anti-virus, anti-spam and
content filtering.http://www.mailguard.com.au/mg
More information about the juniper-nsp
mailing list