[j-nsp] Set weight (BGP attribute) in JunOS

[Ali Sumsam]

Hi Saku,
Actually I am working on migration from Cisco to Juniper.
On Cisco router weight attribute is used and have to set same preference
same on Juniper.

Thats where I found that there is no weight in Juniper.
Good to know some thing :).

Regards,
*Ali Sumsam CCIE*
*Network Engineer - Level 3*
eintellego Pty Ltd
ali at eintellego.net ; www.eintellego.net

Phone: 1300 753 383 ; Fax: (+612) 8572 9954

Cell +61 (0)410 603 531

facebook.com/eintellego
PO Box 7726, Baulkham Hills, NSW 1755 Australia

The Experts Who The Experts Call
Juniper - Cisco – Brocade - IBM



On Sun, Nov 25, 2012 at 9:03 PM, Saku Ytti <saku at ytti.fi> wrote:

> On (2012-11-25 19:03 +1100), Ali Sumsam wrote:
>
> > I am configuring BGP for one of my customer's MX-5 router. I need to
> > configure the BGP attribute "weight"
>
> There is no BGP attribute 'weight' it's Cisco proprietary hinvention. What
> are you trying to accomplish where you think you need to set weight in
> JunOS?
>
> > I googled it and found following, which kinda says that we cant play with
> > weight attribute in policies. Is this correct?
> >
> >
> http://www.juniper.net/techpubs/software/erx/erx41x/swconfig-routing-vol2/html/bgp-config9.html
>
> This is ERX, which is much closer to IOS than JunOS.
>
> --
>   ++ytti
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>