[j-nsp] QinQ on MX5

[Massimo Ravizza]

Hi,
I need to connect an interface of an EX2200 with an MX5. On this interface
I do QinQ:

set interfaces ge-0/1/1 unit 0 family ethernet-switching port-mode trunk
--> interface to MX
set interfaces vlan unit 2 family inet address X.X.X.X
set vlans svlan1 vlan-id 3001
set vlans svlan1 interface ge-0/1/1.0
set vlans svlan1 dot1q-tunneling customer-vlans 2
set vlans svlan1 dot1q-tunneling customer-vlans 10
set vlans svlan1 dot1q-tunneling customer-vlans 20
set vlans vlan2 description Management
set vlans vlan2 vlan-id 2
set vlans vlan2 l3-interface vlan.2

On MX side, this kind of configuration is not possible. I tried to use
vlan-map, but MX doen't like it:



[edit interfaces]
+   ge-1/1/5 {
+       vlan-tagging;
+       mtu 9192;
+       encapsulation flexible-ethernet-services;
+       unit 2 {
+           description MANAGEMENT;
+           vlan-id 2;
+           input-vlan-map pop;
+           output-vlan-map {
+               push;
+               tag-protocol-id 0x8100;
+               vlan-id 3001;
+           }
+           family inet {
+               mtu 1500;
+               address X.X.X.X;
+           }
+       }
+       unit 401 {
+           description "VLAN DATI";
+           vlan-id 401;
+           input-vlan-map pop;
+           output-vlan-map {
+               push;
+               tag-protocol-id 0x8100;
+               vlan-id 3002;
+           }
+           family inet {
+               mtu 1500;
+               address X.X.X.X;
+           }
+           family mpls;
+       }
+       unit 402 {
+           description "VLAN INTERNET";
+           vlan-id 402;
+           input-vlan-map pop;
+           output-vlan-map {
+               push;
+               tag-protocol-id 0x8100;
+               vlan-id 3002;
+           }
+           family inet {
+               mtu 1500;
+               address X.X.X.X;
+           }
+           family mpls;
+       }
+   }
+   vlan {
+       unit 2 {
+           family inet {
+               address X.X.X.X;
+           }
+       }
+   }

[edit]
# commit check
[edit interfaces ge-1/1/5]
  'unit 2'
    vlan map ge-1/1/5: input-vlan-map or output-vlan-map can only be
specified in vlan-ccc, extended-vlan-ccc, vlan-vpls or extended-vlan-vpls
encapsulations
error: configuration check-out failed

Do you have some suggestion?
Thanks