[j-nsp] EVPN/VXLAN on QFX5100

[Tim Jackson]

You can run VXLAN over an MPLS LSP on QFX5100 just fine.. As long as the L3
lookup for the remote VTEP goes across an LSP the VXLAN traffic will too..

But it's not l2ompls.. it's l2ovxlanoipompls.....

--
Tim

On Aug 3, 2016 6:52 PM, "Chris Kawchuk" <juniperdude at gmail.com> wrote:

> You cannot use MPLS as the "underlay" Transport on QFX51xx. I tried the
> same -- you need to use VxLAN as the "transport LSP" so to speak. (Think of
> VXLAN remote VTEP IP address as being the outer label, and the VNI is the
> inner label.)
>
> There's a config guide floating around out there on the JNPR Website fort
> the QFX manual showing how to setup the VTEPs so that the switches setup an
> "inet.3" table between each other for remote-next-hop resolution (from
> iBGP/MP-BGP sessions), pointing to a remote VTEP IP.
>
> Good luck! Would be nice if they could do MPLS as the underlay, but
> <-insert Trident2+ Pipeline issues-> here.
>
> - CK.
>
>
> On 4 Aug 2016, at 7:19 am, Joe Freeman <joe at netbyjoe.com> wrote:
>
> > The QFX's are connected via an MPLS/IP connection with LDP/RSVP/ISIS, and
> > MP-IBGP.
> >
> > A show evpn instance extensive command shows that the two switches see
> each
> > other, but I am unable to learn mac addresses between them.
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp
>