[j-nsp] Packet capturing on SRX5400

Per Westerlund p1 at westerlund.se
Sat Feb 18 08:43:05 EST 2017


I do believe that it is not until you stop the capture that all data is 
flushed to the capture-file. If you have a small enough flow, the file 
will be empty until you stop the capture.

/Per

On 17 Feb 2017, at 17:44, Jonathan Call wrote:

> I followed the instructions listed here to create and start a capture 
> for a single destination IP address on an SRX5400 in a lab:
>
>
> https://kb.juniper.net/InfoCenter/index?page=content&id=KB21563
>
>
>  I can see a flow for the IP when I run a "show security flow session 
> destination-prefix 172.16.x.x/32" but no traffic is captured. The file 
> size remains at zero.
>
>
> I'm new to this platform so any suggestions would be appreciated.
>
>
> Jonathan
>
> _______________________________________________
> juniper-nsp mailing list juniper-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/juniper-nsp


More information about the juniper-nsp mailing list