[j-nsp] Juniper BFD session with Huawei

[Gökhan Gümüş]

Dear group,

I am trying to establish a RSVP-OAM between a Juniper and Huawei device.


set  protocols mpls label-switched-path Juniper-Huawei oam
bfd-liveness-detection minimum-interval 100
set  protocols mpls label-switched-path Juniper-Huawei oam
bfd-liveness-detection multiplier 3
set  protocols mpls label-switched-path Juniper-Huawei oam
bfd-liveness-detection failure-action make-before-break teardown-timeout 10
set  protocols mpls label-switched-path Juniper-Huawei link-protection
set  protocols mpls label-switched-path Juniper-Huawei adaptive

set protocols mpls label-switched-path Juniper-Huawei to 1.1.1.2


Address                  State     Interface      Time     Interval
Multiplier
127.0.0.1                Down      ae9.0          0.000     2.000        3
 Client RSVP-OAM, TX interval 0.100, RX interval 0.100
 Local diagnostic None, remote diagnostic None
 Remote state AdminDown, version 1
 Session type: Multi hop BFD
 Min async interval 0.100, min slow interval 2.000
 Adaptive async TX interval 2.000, RX interval 2.000
 Local min TX interval 2.000, minimum RX interval 0.100, multiplier 3
 Remote min TX interval 0.000, min RX interval 0.000, multiplier 0
 Local discriminator 29, remote discriminator 0
 Echo mode disabled/inactive, no-absorb, no-refresh
 LSP-Name Juniper-Huawei
  Session ID: 0x0

As Juniper is using 127.0.0.1 as a source address, it is not possible
Huawei to understand this. Is there anyone who has an experience with MPLS
OAM configuration between Juniper and other vendors like Cisco and Huawei?
Is it possible to bring the session up from Juniper towards other vendors?

Kind regards,
Gokhan