[j-nsp] Fusion using vMX and vQFX

[Aaron Gould]

Ok thanks

...was purely a training/familiarization question as an attempt to spin-up some fusion in my eve-ng lab

I'll resort to my hardware, which is limited, but good gear... mx960, mx204, qfx5120.... of which I only have 1-each in my lab... but it's good nonetheless

Thanks
-Aaron

-----Original Message-----
From: Tobias Heister [mailto:lists at tobias-heister.de] 
Sent: Friday, April 12, 2019 9:24 AM
To: Aaron Gould; juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] Fusion using vMX and vQFX

Hi,

On 12.04.2019 15:34, Aaron Gould wrote:
> Can I do Fusion using vMX and vQFX ?  Will it work?

Leaving aside the use case and what you would actually want/could to do with it this will not work.
vQFX is basically QFX10k and QFX10k can not be used as Sat in any Fusion deployment (it can be AD in DC flavor).

So even if Fusion would be supported and/or work on vMX (which i doubt) there would be no virtual SAT to connect.
Also of course you would need a License for the AD in Fusion PE (which uses MX as AD) in order to use it.

Even MX150 (which is vMX on NFX Appliance) is not supported as AD for fusion.

-- 
regards
Tobias