[j-nsp] MIC3-3D-1X100GE-CXP ports won't light up.

[Dave Peters - Terabit Systems]

Hey everybody--

It's looking more likely that I have a cable issue, here, and just need to get that replaced. I've got two dozen LC cables around here. Fat lot of good that does me, now.

Appreciate everybody talking me down from the ledge.  Have a great week.

--Dave Peters
________________________________________
From: Litterick, Jeff  (BIT) [Jeff.Litterick at state.sd.us]
Sent: Wednesday, January 30, 2019 7:34 AM
To: Jerry Jones; Dave Peters - Terabit Systems
Cc: juniper-nsp at puck.nether.net
Subject: RE: [j-nsp] MIC3-3D-1X100GE-CXP ports won't light up.

After bringing up the same config (Expect we use LR4 Optics) and same OS level for over 12 setups in the past 2 months we did run into one problem that looks similar to this.  We would get a link light but the interface would remain down

First  Make sure to check to see if you are seeing light on both ends using the show interfaces diagnostics optics command .  If not then something is wrong with the cable or optic.   We never had to activate anything outside the MPC card when it was inserted.

In our case we would see light on both ends but both sides the interface on both sides would remain down.   We had to do a disable on just one side of the link and then reenable it and then the interfaces on both sides would come online.   This happened in 10 of the 12 connections.  And also we only ever had to do this once when everything was when the cable was first plugged in even if the cards had been plugged in for weeks..  We have since unplugged, pulled cards out, rebooted the entire chassis though a full power off and never had to do the disable trick again for that connection.       I was up to this point blaming the infernia gear in the middle.

-----Original Message-----
From: juniper-nsp [mailto:juniper-nsp-bounces at puck.nether.net] On Behalf Of Jerry Jones
Sent: Wednesday, January 30, 2019 4:38 AM
To: Dave Peters - Terabit Systems <Dave at terabitsystems.com>
Cc: juniper-nsp at puck.nether.net
Subject: Re: [EXT] [j-nsp] MIC3-3D-1X100GE-CXP ports won't light up.

Simple - but did you turn on the laser?


On Jan 29, 2019, at 4:16 PM, Dave Peters - Terabit Systems <Dave at terabitsystems.com> wrote:

Hi all--

New to this particular MIC. I've got two Juniper MX480s running RE-S-1800x4s with 15.1R7.9 on SCBE2s with MPC3E cards, and I'm trying to use MIC3-3D-1X100GE-CXP with CXP-100GBASE-SR10 transceiver.

First time, like I said. Got a 24 Fiber MTP Cable, Multimode OM3, 100Gb Female to Female 50/125, OFNP, Pin 1-13 cable.

The ports don't light up or go "up," but the MPCs, MICs, and transceivers are recognized. I'm clearly missing something. Can anyone take some pity on me, here? As always, much appreciated.

--Dave Peters
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp

_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp