[j-nsp] srx ipsec tunnel over mpls l3vpn
Aaron Gould
aaron1 at gvtc.com
Fri Jul 12 09:20:50 EDT 2019
Craig, how did you do the LT config to "cycle" traffic back through ? you
have a link/kb on how-to ? Actually I'm wondering if there's a more elegant
way then LT's (no offense since we all love accomplishing things and making
stuff work, but it seems that LT's and furthermore, physical cables lopped
from port to port on the front of the device, are usually ways to do things
that we can't figure out in software) :|
Hugo, The other end is an MX104 with services card for ipsec capability
(MS-MIC-16G)
I haven't yet put any customer edge interfaces behind the SRX or MX, but I
will do that this morning.... I simply wanted to put a subnet on the secure
tunnel interfaces and ping from st0.0 to ms-0/0/0.1 first, but I can do the
further edge config also.
-Aaron
-----Original Message-----
From: Hugo Slabbert [mailto:hugo at slabnet.com]
Sent: Friday, July 12, 2019 1:26 AM
To: Aaron Gould
Cc: 'Emille Blanc'; juniper-nsp at puck.nether.net
Subject: Re: [j-nsp] srx ipsec tunnel over mpls l3vpn
Is the other end of this also an SRX configured in a similar way, or
something else? This seems to contradict basically any Juniper docs on SRX
around MPLS traffic re: flow/packet mode. Specifically given that it's
showing "drop" for MPLS traffic, I would be confused about how it's passing
MPLS-encap'd traffic.
Can you pass other non-IPSEC IPv4 traffic from the SRX (or behind it) across
the l3vpn to validate bidirectional traffic passing?
--
Hugo Slabbert | email, xmpp/jabber: hugo at slabnet.com
pgp key: B178313E | also on Signal
On Thu 2019-Jul-11 15:34:26 -0500, Aaron Gould <aaron1 at gvtc.com> wrote:
>
>Thanks Emille, Ummm, I may be misunderstanding you , but I don't think
>I have change from SRX flow-mode default. But I do have ldp neighbor
>up and mpls forwarding is occurring via mpls l3vpn vrf . ....and I do
>believe the ike phase 1 and phase 2 is working over this mpls l3vpn within
the srx....
>but I just don't seem to be able to ping from one side of the st0
>tunnel interface to the other.
>
>See...
>
>root at demo-srx300> show security flow status
> Flow forwarding mode:
> Inet forwarding mode: flow based
> Inet6 forwarding mode: drop
> MPLS forwarding mode: drop
> ISO forwarding mode: drop
> Enhanced route scaling mode: Disabled
> Flow trace status
> Flow tracing status: off
> Flow session distribution
> Distribution mode: RR-based
> GTP-U distribution: Disabled
> Flow ipsec performance acceleration: off
> Flow packet ordering
> Ordering mode: Hardware
>
>
>root at demo-srx300> show route table mpls.0
>
>mpls.0: 524 destinations, 524 routes (524 active, 0 holddown, 0 hidden)
>+ = Active Route, - = Last Active, * = Both
>
>0 *[MPLS/0] 04:51:07, metric 1
> Receive
>1 *[MPLS/0] 04:51:07, metric 1
> Receive
>2 *[MPLS/0] 04:51:07, metric 1
> Receive
>13 *[MPLS/0] 04:51:07, metric 1
> Receive
>16 *[VPN/0] 04:51:07
> to table one.inet.0, Pop
>345552 *[LDP/9] 04:43:04, metric 3, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16507
>345568 *[LDP/9] 04:43:04, metric 4, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16508
>345584 *[LDP/9] 04:43:04, metric 2, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16512
>345600 *[LDP/9] 04:43:04, metric 3, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16513
>345616 *[LDP/9] 04:43:04, metric 3, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16516
>345632 *[LDP/9] 04:43:04, metric 4, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16517
>345648 *[LDP/9] 04:43:04, metric 3, tag 0
> > to 10.101.14.197 via ge-0/0/0.0, Swap 16518
>
>root at demo-srx300> show route table mpls.0 terse
>
>mpls.0: 524 destinations, 524 routes (524 active, 0 holddown, 0 hidden)
>+ = Active Route, - = Last Active, * = Both
>
>A V Destination P Prf Metric 1 Metric 2 Next hop AS path
>* ? 0 M 0 1 Receive
>* ? 1 M 0 1 Receive
>* ? 2 M 0 1 Receive
>* ? 13 M 0 1 Receive
>* ? 16 V 0 Table
>* ? 345552 L 9 3 >10.101.14.197
>* ? 345568 L 9 4 >10.101.14.197
>* ? 345584 L 9 2 >10.101.14.197
>* ? 345600 L 9 3 >10.101.14.197
>* ? 345616 L 9 3 >10.101.14.197
>* ? 345632 L 9 4 >10.101.14.197
>* ? 345648 L 9 3 >10.101.14.197
>* ? 345664 L 9 7 >10.101.14.197
>* ? 345680 L 9 6 >10.101.14.197
>* ? 345696 L 9 7 >10.101.14.197
>* ? 345712 L 9 7 >10.101.14.197
>* ? 345728 L 9 6 >10.101.14.197
>* ? 345744 L 9 7 >10.101.14.197
>
>root at demo-srx300> show route table mpls.0 terse | count
>Count: 528 lines
>
>root at demo-srx300> show ldp neighbor
>Address Interface Label space ID Hold time
>10.101.14.197 ge-0/0/0.0 10.101.0.254:0 10
>
>root at demo-srx300>
>
>
>
>-----Original Message-----
>From: Emille Blanc [mailto:emille at abccommunications.com]
>Sent: Thursday, July 11, 2019 3:04 PM
>To: Aaron Gould; juniper-nsp at puck.nether.net
>Subject: RE: [j-nsp] srx ipsec tunnel over mpls l3vpn
>
>Based on what you described, it sounds like you already got your
>MPLS/LDP running in a packet-mode routing-instance, as otherwise MPLS
>is dropped on an SRX in flow mode.
>
>No obvious ideas with the output provided otherwise.
>Do the flows in your IPSEC instance get created?
>
>-----Original Message-----
>From: juniper-nsp [mailto:juniper-nsp-bounces at puck.nether.net] On
>Behalf Of Aaron Gould
>Sent: Thursday, July 11, 2019 12:27 PM
>To: juniper-nsp at puck.nether.net
>Subject: [j-nsp] srx ipsec tunnel over mpls l3vpn
>
>Anyone ever done it ? To be clear, I have mpls/ldp/ospf/bgp enabled
>the SRX such that I have an l3vpn functional into the SRX.
>
>
>
>I have a lo0.99 interface as the external interface used for ike/ipsec.
>Seems that I'm pretty close to getting this done, as i have ike phase 1
>up and ike phase 2 up, but only seeing encrypted packets as I try to
>ping between the st0.0 interface and the ms-0/0/0.1 inside interface on
>the other side (mx104 with ms-mic-16g)
>
>
>
>Let me know what I'm missing.
>
>
>
>I'm seeing drops in these to show outputs. which seems to coincide with
>a 100-packet ping test...
>
>
>
>
>
>root at demo-srx300> show security flow statistics
>
> Current sessions: 9
>
> Packets forwarded: 417926
>
> Packets dropped: 15604
>
> Fragment packets: 0
>
> Pre fragments generated: 0
>
> Post fragments generated: 0
>
>
>
>root at demo-srx300> show security flow status
>
> Flow forwarding mode:
>
> Inet forwarding mode: flow based
>
> Inet6 forwarding mode: drop
>
> MPLS forwarding mode: drop
>
> ISO forwarding mode: drop
>
> Enhanced route scaling mode: Disabled
>
> Flow trace status
>
> Flow tracing status: off
>
> Flow session distribution
>
> Distribution mode: RR-based
>
> GTP-U distribution: Disabled
>
> Flow ipsec performance acceleration: off
>
> Flow packet ordering
>
> Ordering mode: Hardware
>
>
>
>root at demo-srx300> show security ipsec statistics
>
>ESP Statistics:
>
> Encrypted bytes: 252264
>
> Decrypted bytes: 0
>
> Encrypted packets: 1618
>
> Decrypted packets: 0
>
>AH Statistics:
>
> Input bytes: 0
>
> Output bytes: 0
>
> Input packets: 0
>
> Output packets: 0
>
>Errors:
>
> AH authentication failures: 0, Replay errors: 0
>
> ESP authentication failures: 0, ESP decryption failures: 0
>
> Bad headers: 0, Bad trailers: 0
>
>
>
>root at demo-srx300> show security flow statistics | grep rop
>
> Packets dropped: 15650
>
>
>
>root at demo-srx300> ping 10.102.199.66 routing-instance one rapid
>interval .1 count 100
>
>PING 10.102.199.66 (10.102.199.66): 56 data bytes
>
>...........................................................................
.
>........................
>
>--- 10.102.199.66 ping statistics ---
>
>100 packets transmitted, 0 packets received, 100% packet loss
>
>
>
>root at demo-srx300> show security ipsec statistics
>
>ESP Statistics:
>
> Encrypted bytes: 267864
>
> Decrypted bytes: 0
>
> Encrypted packets: 1718
>
> Decrypted packets: 0
>
>AH Statistics:
>
> Input bytes: 0
>
> Output bytes: 0
>
> Input packets: 0
>
> Output packets: 0
>
>Errors:
>
> AH authentication failures: 0, Replay errors: 0
>
> ESP authentication failures: 0, ESP decryption failures: 0
>
> Bad headers: 0, Bad trailers: 0
>
>
>
>root at demo-srx300> show security flow statistics | grep rop
>
> Packets dropped: 15755
>
>
>
>-Aaron
>
>
>
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/juniper-nsp
>
>
>_______________________________________________
>juniper-nsp mailing list juniper-nsp at puck.nether.net
>https://puck.nether.net/mailman/listinfo/juniper-nsp
More information about the juniper-nsp
mailing list