[j-nsp] Converting QFX3600 from QF Interconnect to standalone mode

[Vincentz Petzholtz]

Hi Daniel,

Have you checked IF the device model in question is capable of running in "standalone" mode?
As far as I remember there were models which did not support it (especially the ones used for IC in a jnp qfabric).

Best regards,
Vincentz
--

Am 04.02.2023 um 23:21 schrieb Daniel Roesen via juniper-nsp <juniper-nsp at puck.nether.net>:

Hi,

just trying to convert a couple of QFX3600 QFabric interconnet nodes to
standalone mode via "request chassis device-mode standalone". They
state "after next boot: standalone", but come up again in QF-IC mode,
still stating "after next boot: standalone".

JUNOS 13.1X50-D15.1

The conversion worked sorta fine with the QFX3500s, but all QFX3600 do
fail...

Anybody got a clue how to beat them into submission?

Best regards,
Daniel

--
CLUE-RIPE -- Jabber: dr at cluenet.de -- dr at IRCnet -- PGP: 0xA85C8AA0
_______________________________________________
juniper-nsp mailing list juniper-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp