<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<meta http-equiv="content-type" content="text/html;
charset=ISO-8859-1">
</head>
<body bgcolor="#ffffff" text="#000000">
<br>
Trying to connect GE copper SFP on MX to a 100meg port on a cisco
switch, 3560 actually.<br>
<br>
<pre wrap="">ge-0/0/2 {
description "<< Test Link >>";
enable;
speed 100m;
link-mode full-duplex;
unit 0 {
family inet {
address 192.168.1.2/26;
show interface ge-0/0/2:
Physical interface: ge-0/0/2, Enabled, Physical link is Up
Interface index: 136, SNMP ifIndex: 511
Description: << Test Link >>
Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, BPDU Error: None, MAC-REWRITE Error: None, Loopback: Disabled, Source filtering: Disabled, Flow control: Enabled,
Auto-negotiation: Enabled, Remote fault: Online
Device flags : Present Running
Interface flags: SNMP-Traps Internal: 0x4000
Link flags : None
CoS queues : 8 supported, 8 maximum usable queues
Current address: 80:71:1f:91:10:02, Hardware address: 80:71:1f:91:10:02
Last flapped : 2011-04-28 13:44:09 PDT (1w5d 03:08 ago)
Input rate : 0 bps (0 pps)
Output rate : 0 bps (0 pps)
Active alarms : None
Active defects : None
Logical interface ge-0/0/2.0 (Index 74) (SNMP ifIndex 522)
Flags: SNMP-Traps 0x4000000 Encapsulation: ENET2
Input packets : 0
Output packets: 19
Protocol inet, MTU: 1500
Flags: Sendbcast-pkt-to-re
Addresses, Flags: Is-Preferred Is-Primary
Destination: 192.168.1.0/26, Local: 192.168.1.2, Broadcast: 192.168.1.63
Protocol multiservice, MTU: Unlimited
Swapped cables, xover and straight. Setup the cisco port as access/vlan and a routed port
hardcoding the speed/duplex and auto and I can not get a link between the devices.
My question is can these 1000BaseT SFP's work at 100M? I can configure them as such
but do they actually work at 100M?
Thanks,
Keith
</pre>
<br>
<br>
<br>
</body>
</html>