[rbak-nsp] Clips and DHCP relay problem

[Rafal]

Hello Thomas,


I found reason after digging some old manuals.
The subscriber record or profile must have no IP address configured.
My  radius response (Framed-IP-Address) always contained same IP address as IP provided by
DHCP. Removing this from radius response fixed problem.

Thanks for your time.

Rafal



Tuesday, October 13, 2015, 4:59:51 PM, you wrote:

> Hi Rafal,

> you wrote:

>> Can  you  show me how do you bind them on card ?

> nothing special so far:

> ###############################################
> port ethernet 11/3 
> mtu 9000
>  no shutdown
>  encapsulation dot1q
>  dot1q pvc 101 profile TrustQoS encapsulation 1qtunnel 
>   dot1q pvc 101:10 profile TrustQoS 
>    track vrrp 255 vrrp_sub_side-1 thdsl-hsi
>   service clips dhcp context thdsl-hsi
> ###############################################

> Context "thdsl-hsi" is where the multibind interface and subscriber
> config is within (see my last config snippets).
> We are using Q-in-Q (S-VLAN 101, C-VLAN 10) and some VRRP tracking.
> But this shouldn't matter if you are not using it.

> --
> Regards
> Thomas 

> _______________________________________________
> redback-nsp mailing list
> redback-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/redback-nsp



-- 
Best regards,
Ozga Rafal                          mailto:golem at mtm-info.pl