[VoiceOps] Odd network problem with SIP
Ujjval Karihaloo
ujjval at simplesignal.com
Sat Jun 21 11:58:01 EDT 2014
wireshark can show chksum incorrectly at times.
Ujjval K
> On Jun 21, 2014, at 9:37 AM, Jay Ashworth <jra at baylink.com> wrote:
>
> I have a client using the Spitfire dialler on Win7 to dial via SIP to a
> carrier called VoxTelecom; I infer they're a virtual carrier because the
> SIP goes to their Sonus SBC at a single IP, but the media sessions go all
> over creation.
>
> The client has been having completion trouble, and the dialler folks said
> "crappy circuit; too much jitter and packet loss", tested from the dialler
> using PingPlotter. I don't think it was jitter, I think it was ping response
> deviation; PingPlotter doesn't appear to actually test jitter.
>
> But to tick the boxes, I had road runner out; they replaced a ubee D2 modem
> with their New Hawtness Arris D3 modem; no change. All his analog measurements
> were pristine, he told me.
>
> So next step, check the router. Log in to the Fortigate 40D; control panel
> won't paint properly. This *may* have been an IE10 compatibility mode
> red-herring, but I temporarily swapped it for a 20C, which I could talk to.
>
> Set up the inbound DNATs for udp/5060 SIP and upd/49152-49252 RTP.
>
> Ran some calls.
>
> They're not seeing my ACK after they send me an SDP. They get the invite, but
> not the ACK. I send RTP, but they don't bother cause they think the call's
> not set up yet.
>
> Wireshark on the dialler... that ACK packet *has a bad IP header checksum*.
>
> Not the earlier packets; just the ACK. Huh?
>
> So, assume it's the OS, somehow; reboot. 65 Windows updates and an hour later...
>
> Set everything back up, and run more test calls. This time, the Invite has a bad
> IP header checksum. Look at clock, 6pm EDT. Give up, go home.
>
> I'm going to go back to the original router Monday morning, and check the
> compatibility mode theory, but has anyone ever seen "just certain sent packets
> show up with a bad IP header checksum, as monitored on-machine"?
>
> (I know that the original 40D router might well *have* a problem, and that the
> checksum thing is orthogonal to the original problem -- since older pcaps show
> clean setups -- but at least I can confirm I have the NATs configured right.)
>
> Cheers,
> -- jra
>
> --
> Jay R. Ashworth Baylink jra at baylink.com
> Designer The Things I Think RFC 2100
> Ashworth & Associates http://www.bcp38.info 2000 Land Rover DII
> St Petersburg FL USA BCP38: Ask For It By Name! +1 727 647 1274
> _______________________________________________
> VoiceOps mailing list
> VoiceOps at voiceops.org
> https://puck.nether.net/mailman/listinfo/voiceops
More information about the VoiceOps
mailing list