[VoiceOps] Adding CIC on Acme SBC

[Mark Lindsey]

Yes, but doing so depends on the receiving device caring about your concept of carrier. There are several ways this is commonly done in the signaling; in the Acme Packet SBC, you'd use a sip-manipulation rule to modify the Request URI.


So
INVITE sip:12293160013 at 4.1.2.3;user=phone SIP/2.0

might need to become RFC4694...
INVITE sip:12293160013;cic=0123 at 4.1.2.3;user=phone SIP/2.0

(Dialogic has a nice page about this: http://www.dialogic.com/webhelp/img1010/10.3.3er2/webhelp/Description/Interworking/SIP_Carrier_Identification_Code.htm)

or...
INVITE sip:12293160013;cic=0123;csel=sub at 4.1.2.3;user=phone SIP/2.0

or, also not uncommon if the call is going into a US-based telephone switch configured for carrier-equal-access dialing:
INVITE sip:101023412293160013 at 4.1.2.3;user=phone SIP/2.0

or, even,
INVITE sip:12293160013 at 4.1.2.3;user=phone;dtg=0123 SIP/2.0
...when the dtg URI parameter is mapped to a carrier. 

It really depends on what the receiving device can interpret.

Mark R Lindsey, SMTS 
+1-229-316-0013
mark at ecg.co
http://ecg.co/lindsey/



> On Oct 4, 2016, at 09:39 , frnkblk at iname.com wrote:
> 
> Is it possible to add a CIC code to an outgoing call on an Acme SBC?
> 
> Frank
> 
> _______________________________________________
> VoiceOps mailing list
> VoiceOps at voiceops.org
> https://puck.nether.net/mailman/listinfo/voiceops