[c-nsp] PA-2FE-TX using both ports kills module

[FreeLSD]

On Sat, Sep 24, 2005 at 07:16:32PM +0200, Gert Doering wrote:
> Hi,
> 
> On Sun, Sep 25, 2005 at 01:13:24AM +1200, Nikolai Schupbach wrote:
> > We have a PA-2FE-TX in a 7206VXR /w NPE400. We have not be successful in
> > getting both ports working in this module. 
> 
> Sounds oh so familiar.
> 
> > If we run this module using a single port everything is stable and fine. 
> 
> Does it work if you run port 1 as "single port"?  Or only "port 0"?

In my case work only port 0. 

If I try passing traffic throught port 1 then card do fail... with or 
without traffic on port 0. 

> >         PCB Serial Number        : JAE091283VD

JAE... 

> 
> All reports seen here in this list that had issues with PA-2FE-TXs have 
> HW rev 1.00 / board revision B0.
> 
> We swapped the faulty one in our 7200 to a PA-2FE-TX with revision C0,
> and both ports are working perfectly well now...

> It would be perfect if you could open a TAC case on this, so this could
> finally be tracked down (we can't right now).
 
can't.