[cisco-voip] FXS module breaking

[David Wilson]

Hi Mike,

Thanks for your response.
>From what I can understand it seems the FXS module just stops working. Are 
the some tests I could perhaps run in the router to give me more info ?


Kindest regards
David Wilson
_______________________________
D c D a t a
Tel +27 33 342 7003
Fax +27 33 345 4155
Cell +27 82 4147413
http://www.dcdata.co.za
support at dcdata.co.za
Powered by Linux, driven by passion !
_______________________________

"Computers are not intelligent. They only think they are."

----- Original Message ----- 
From: "Mike Armstrong" <mfa at crec.ifas.ufl.edu>
To: <cisco-voip at puck.nether.net>; <dave at dcdata.co.za>
Sent: Tuesday, March 01, 2005 1:39 PM
Subject: [cisco-voip] FXS module breaking


> What't the nature of the connection?  I'm wondering if an induced current 
> is zapping the analog interface -- lightning, wire passing by a large load 
> of some kind, etc.  Any more detail about exactly what "breaking" means?
>
> Mike Armstrong
> UF/IFAS CREC
> Lake Alfred, FL