Fwd: [cisco-voip] Long Distance on PRI - Callmanager

[Nick Marus]

---------- Forwarded message ----------
From: Nick Marus <nmarus at gmail.com>
Date: Thu, 10 Mar 2005 14:28:06 -0500
Subject: Re: [cisco-voip] Long Distance on PRI - Callmanager
To: Jack Lyons <jack.lyons at martinagency.com>


Thanks, That did it!


On Thu, 10 Mar 2005 14:22:57 -0500, Jack Lyons
<jack.lyons at martinagency.com> wrote:
> I think you have to do no mgcp and then mgcp on the gateway for the changes
> to take affect.
>
> Jack
>
> -----Original Message-----
> From: Nick Marus [mailto:nmarus at gmail.com]
> Sent: Thursday, March 10, 2005 1:52 PM
> To: Wes Sisk
> Cc: Voll, Scott; cisco-voip at puck-nether.net
> Subject: Re: [cisco-voip] Long Distance on PRI - Callmanager
>
> I figured thats where the issue was, however it's still doing the same
> thing after making those changes.
>
> I have "Called party IE number type unknown" set to national
>
> and
>
> "Called Numbering Plan" set to ISDN
>
> Here is a q931 trace:
>
> *Mar 10 18:45:12.759: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8  callref =
> 0x0002
>        Bearer Capability i = 0x8090A2
>                Standard = CCITT
>                Transer Capability = Speech
>                Transfer Mode = Circuit
>                Transfer Rate = 64 kbit/s
>        Channel ID i = 0xA98397
>                Exclusive, Channel 23
>        Facility i = 0x9F8B0100A10C0201010201008004546F6464
>        Progress Ind i = 0x8083 - Origination address is non-ISDN
>        Display i = 'Todd'
>        Calling Party Number i = 0x0181, '209'
>                Plan:ISDN, Type:Unknown
>        Called Party Number i = 0xA1, '19547273587'
>                Plan:ISDN, Type:National
> *Mar 10 18:45:12.907: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8
> callref = 0x8002
>        Channel ID i = 0xA98397
>                Exclusive, Channel 23
> *Mar 10 18:45:13.207: ISDN Se0/0/0:23 Q931: RX <- PROGRESS pd = 8
> callref = 0x8002
>        Cause i = 0x82FF - Interworking error; unspecified
>        Progress Ind i = 0x8281 - Call not end-to-end ISDN, may have
> in-band info
> *Mar 10 18:45:18.579: ISDN Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8
> callref = 0x0002
>        Cause i = 0x8090 - Normal call clearing
> *Mar 10 18:45:18.855: ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8
> callref = 0x8002
> *Mar 10 18:45:18.863: ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8
> callref = 0x0002
>
> On Thu, 10 Mar 2005 13:06:40 -0500, Wes Sisk <wsisk at cisco.com> wrote:
> > Unfortunately not, it is an outstanding feature request: CSCdt68985.
> > Ring up your Cisco SE.
> >
> > /Wes
> >
> > Voll, Scott wrote:
> >
> > >Nick--
> > >
> > >This is done on the Gateway interface config at the bottom.
> > >
> > >Device -- Gateway -- click on gateway interface -- Scroll to bottom
> > >
> > >Look under Outbound calls.
> > >
> > >You would change called party ie number type to national and called
> > >numbering plan to ISDN.
> > >
> > >I'm not sure if this will fix everything though.  He said the tollfree
> > >needs to be unknown and I don't know if there is a way to specify both
> > >national and unknown via a route pattern.
> > >
> > >Scott
> > >
> > >-----Original Message-----
> > >From: cisco-voip-bounces at puck.nether.net
> > >[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Nick Marus
> > >Sent: Thursday, March 10, 2005 9:50 AM
> > >To: cisco-voip at puck-nether.net
> > >Subject: [cisco-voip] Long Distance on PRI - Callmanager
> > >
> > >Just cutting over a pri circuit, dms-100 with ni2 emulation. Local and
> > >toll free dialing work fine. Yet long distance does not. the provider
> > >is saying I need to flag long distance call as "national" and tollfree
> > >as "unknown". The onsite tech used his tbird to place a long distance
> > >call successfully as well...
> > >
> > >Any idas? Not sure where I'd adjust this? The gateway is 2821 setup with
> > >mgcp.
> > >
> > >Thanks,
> > >
> > >
> > >
> >
>
> --
> Nick Marus
> nmarus at gmail.com
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> This email and its contents may be confidential.  If it is and you are not
> the intended recipient, please do not disclose or use the information within
> this email or its attachments.  If you have received this email in error,
> please delete it immediately.  Thank you.
>
>

--
Nick Marus
nmarus at gmail.com


-- 
Nick Marus
nmarus at gmail.com