[cisco-voip] IP Phone 7960 Configuration

[Voll, Scott]

On our 3550 we don't use the trunk command.

interface FastEthernet0/2
 switchport access vlan 10
 switchport mode dynamic desirable
 switchport voice vlan 110

Scott

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jon Carnes
Sent: Friday, March 25, 2005 5:36 AM
To: Alejandro Méndez Chávez; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] IP Phone 7960 Configuration

Do you mean the setup of the switches or the phone?  I can't think of
anything special to do on the phone side, so here is my take on setting up
the switch port...

In general we setup the switch with a separate vlan for voice. In most cases
I use Vlan 10 for voice and the default Vlan for data. Here is a typical
ports settings:
 interface FastEthernet0/2
   switchport trunk encapsulation dot1q
   switchport mode trunk
   switchport voice vlan 10

Good Luck,

Jon Carnes
FeatureTel

----- Original Message ----- 
From: "Alejandro Méndez Chávez" <rawsecurity at gmail.com>
To: <cisco-voip at puck.nether.net>
Sent: Friday, March 25, 2005 1:23 AM
Subject: [cisco-voip] IP Phone 7960 Configuration


> How is the best way to configure 7960 IP Phone on Catalyst 3550 and
> 2950 switchs?
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip