[cisco-voip] Change default codec G729 to G711

[Paulo Gomes]

Hello Jaured, Thanks, I apreciate your help.

I alredy trie that. But the real problem is that I have two routers and in
the router1 I configure with that options, but on router2 I can't configure
that because is directly to the fxs port. If I don't change the codec, is
used the G.729!
Here is the design.


(PBX Router1)--------(FXS Router2)
  |                    |
  |                    |
Phone1                Phone2

My problem is that in the dial peer pots of FXS I cant change the codec,
then the what realy hapens is one ring on phone2 and then the cal lis lost.




-----Mensagem original-----
De: Jared Mauch [mailto:jared at puck.nether.net] 
Enviada: quinta-feira, 31 de Março de 2005 0:59
Para: Paulo Gomes
Cc: cisco-voip at puck.nether.net
Assunto: Re: [cisco-voip] Change default codec G729 to G711

	you can set it in the dial-peer

	eg:

!
dial-peer voice 1000 voip
 destination-pattern 1...
 session protocol sipv2
 session target ipv4:10.2.3.4
 session transport udp
 dtmf-relay rtp-nte
 codec g711ulaw
 no vad
!


On Thu, Mar 31, 2005 at 12:42:43AM +0100, Paulo Gomes wrote:
> 
> Hello ppl
> 
> Does some body knows how can I change de default codec G729 to G711 on
cisco 2600 series?
> 
> I know I can use the command voice class, but I would like to put de G711
for prefered default!

-- 
Jared Mauch  | pgp key available via finger from jared at puck.nether.net
clue++;      | http://puck.nether.net/~jared/  My statements are only mine.