[cisco-voip] Change default codec G729 to G711

[Wes Sisk]

Paulo,

Every calll that traverses a router matches 2 dial-peers: an inbount 
peer and an outbound peer.  You will need to specify g711 under the 
incoming VOIP dail-peer of the destination router.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

/Wes

Paulo Gomes wrote:

>Hello Jaured, Thanks, I apreciate your help.
>
>I alredy trie that. But the real problem is that I have two routers and in
>the router1 I configure with that options, but on router2 I can't configure
>that because is directly to the fxs port. If I don't change the codec, is
>used the G.729!
>Here is the design.
>
>
>(PBX Router1)--------(FXS Router2)
>  |                    |
>  |                    |
>Phone1                Phone2
>
>My problem is that in the dial peer pots of FXS I cant change the codec,
>then the what realy hapens is one ring on phone2 and then the cal lis lost.
>
>
>
>
>-----Mensagem original-----
>De: Jared Mauch [mailto:jared at puck.nether.net] 
>Enviada: quinta-feira, 31 de Março de 2005 0:59
>Para: Paulo Gomes
>Cc: cisco-voip at puck.nether.net
>Assunto: Re: [cisco-voip] Change default codec G729 to G711
>
>	you can set it in the dial-peer
>
>	eg:
>
>!
>dial-peer voice 1000 voip
> destination-pattern 1...
> session protocol sipv2
> session target ipv4:10.2.3.4
> session transport udp
> dtmf-relay rtp-nte
> codec g711ulaw
> no vad
>!
>
>
>On Thu, Mar 31, 2005 at 12:42:43AM +0100, Paulo Gomes wrote:
>  
>
>>Hello ppl
>>
>>Does some body knows how can I change de default codec G729 to G711 on
>>    
>>
>cisco 2600 series?
>  
>
>>I know I can use the command voice class, but I would like to put de G711
>>    
>>
>for prefered default!
>
>  
>