[cisco-voip] shared line on ATA186
Ryan Ratliff
rratliff at cisco.com
Tue Jun 6 12:30:25 EDT 2006
How about adding them to a broadcast line group?
-Ryan
On Jun 6, 2006, at 11:32 AM, Frazee, Timothy wrote:
All,
I have a question about setup a shared line on both port of a ATA186.
CCM version is 4.1.3sr3a
Load for the ATA is: ATA030203SCCP051201A
Codec will be 711 on both ports with no possibilty of needing to xcode.
The reason is that I am setting up an overhead ringer on a Bogen Amp
that has a bell input. I am not sure if I can dasey-chain the two
amps together off of one ATA port. If i can, then i will just use one
port and nevermind then :)
Thanks.
This message and any attachments are intended only for the use of the
addressee and may contain information that is privileged and
confidential. If the reader of the message is not the intended
recipient or an authorized representative of the intended recipient,
you are hereby notified that any dissemination of this communication
is strictly prohibited. If you have received this communication in
error, please notify us immediately by e-mail and delete the message
and any attachments from your system.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
More information about the cisco-voip
mailing list