[cisco-voip] shared line on ATA186
Frazee, Timothy
Timothy_Frazee at adp.com
Tue Jun 6 11:32:04 EDT 2006
All,
I have a question about setup a shared line on both port of a ATA186.
CCM version is 4.1.3sr3a
Load for the ATA is: ATA030203SCCP051201A
Codec will be 711 on both ports with no possibilty of needing to xcode.
The reason is that I am setting up an overhead ringer on a Bogen Amp that has a bell input. I am not sure if I can dasey-chain the two amps together off of one ATA port. If i can, then i will just use one port and nevermind then :)
Thanks.
This message and any attachments are intended only for the use of the addressee and may contain information that is privileged and confidential. If the reader of the message is not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any dissemination of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail and delete the message and any attachments from your system.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060606/827800e8/attachment.html
More information about the cisco-voip
mailing list