[cisco-voip] IP Phones/various firmware loads
Lelio Fulgenzi
lelio at uoguelph.ca
Thu Jun 8 15:37:52 EDT 2006
As far as I know, the only way to have a device on a different load than the device defaults is to put the firmware you want into the device configuration page of the phones you want to keep at a different version. It's worked well in the past, and now, you can even present a list of devices that are not using the device defaults by going to Device > Device Settings > Firmware Load Information and looking to the right hand side for any devices that are not using the default load.
--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
"I can eat fifty eggs." "Nobody can eat fifty eggs."
----- Original Message -----
From: bababooey at cox.net
To: cisco-voip at puck.nether.net
Sent: Thursday, June 08, 2006 3:33 PM
Subject: [cisco-voip] IP Phones/various firmware loads
Is it possbile to have different firmware loads for various models of the IP Phones in CCM 4.1. I have mostly 7960 and 7970 but I want to keep the remote site 7970 at current revision.
Also, I have a 7970 that is stuck on the upgrade splash screen I have tried erase and factory reset to no avail, does anyone have other tips to bring a 7970 back to life.
THanks
Bob
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060608/1dd0015e/attachment.html
More information about the cisco-voip
mailing list