[cisco-voip] debug isdn q931

[Mark Borchers]

Have you set your logging level high enough to show debug traffic?  See the
logging console command args.

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ed Leatherman
Sent: Thursday, June 15, 2006 10:26 AM
To: ciscovoip
Cc: jeff.davis at mail.wvu.edu
Subject: [cisco-voip] debug isdn q931


I'm fairly certain this is something I am doing wrong but I cant find it for
the life of me..

I have 2 ISR routers, 3825 with some T1 interfaces and DSPs for
conferencing. identical firmware loads and configurations, other than 1 has
an FXO card that the other doesn't. 

I'm executing on both routers from seperate SSH sessions:
# term mon
# debug isdn q931

On router A, I can see all the Q931 debug messages go by. On router B, I see
nothing on the SSH session however I know calls are being placed on it ( I
can see the channels going in service etc from RTMT). Could I have something
turned off on router B that doesnt show up in the config? 

-- 
Ed Leatherman
IP Telephony Coordinator
West Virginia University
Telecommunications and Network Operations 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060615/4fcf12da/attachment.html