[cisco-voip] Dial collection
Fedorov, Konstantin
kfedor at amt.ru
Tue Jun 20 11:22:55 EDT 2006
Yes,
I also think about this, a little rash/
But dtmf-relay not pertain to the pots dial-peer.
How I understand ISDN open b-channel and phone work on the tone
So GW receive digits over in-band and out-of-band.
Brian ? is this possible to send connect instead setup_ack
If yes you can configure following
Dial-peer voice xxx pots
Incoming called-number 219
Port 0/0/0:D
No direct-inward-dial
Or try remove Progress Ind i = 0x8083 - Origination address is non-ISDN
On the PBX
-----------------------
Sincerely Yours,
Konstantin Fedorov
-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com]
Sent: Tuesday, June 20, 2006 7:14 PM
To: Fedorov, Konstantin
Cc: Brian Turnbow; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Dial collection
Disabling overlap receiving will probably break the digital pbx
phones ability to dial though :)
You can try disabling dtmf-relay on the inbound pots dial-peer but
this may not work.
-Ryan
More information about the cisco-voip
mailing list