[cisco-voip] Voip application
Carlos Lopez Fernandez
CarlosL at mrs.es
Mon Jun 26 11:30:59 EDT 2006
> Hi all,
> Here its my scenario:
>
> I receive a call via E1 in a 3640 router with an E1 card, then via dial-peer voice XXX voip it goes to another cisco router (2801) who runs a Vxml application, but the call ends ans nothing happens. Via debug, I saw that the application starts but > ...> ..
>
> I try the same vxml in another router directly via a dial-peer voice XXX POTS and run perfectly.
>
> Any ideas¿?
>
> There are the configuration in the routers
>
> Cisco 3640:
>
> Dial-peer voice 123 voip
> Destination-pattern 123
> Session target ipv4:10.10.10.1
> dtmf-relay h245-alphanumeric
> codec g711ulaw
> no vad
>
>
> Cisco 2801
>
> interface Loopback0
> ip address 10.10.11.1 255.255.255.0
> !
> dial-peer voice 123 voip
> service acme
> destination-pattern 123
> session target ipv4:10.10.11.1
> incoming called-number 123
> dtmf-relay h245-alphanumeric
> codec g711ulaw
> no vad
>
>
>
> Thanks in advance
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060626/1d25bf6a/attachment.html
More information about the cisco-voip
mailing list