[cisco-voip] Caller ID with Verizon

[IT]

I am dealing with issues on my PRI in Bethesda, MD with Verizon. I have
used the exact same configuration as with my gateways in California
(with SBC/att), but I have the following problem. When I make any calls
through the gateway, I pass the caller-id information, but the called
party gets the generic "main line" number for the office as the calling
party.
For example, I have attached the output below of me calling my cellphone
through this PRI from extension 3581.
Notice that the calling party is 3014693581, but I call my cellphone and
it appears as 3014693580.
For reference, here is a link to a screen shot of my PRI config from
CallManager.
http://www.avidanross.com/pri_config.pdf

Thanks,
Avidan

DEBUG ISDN Q931 OUTPUT
-----------------------
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 FAX
*Mar 13 21:57:20:                 CODEC_BYTES
*Mar 13 21:57:20:                 NTE_PAYLOAD
*Mar 13 21:57:20:                 DTMF_RELAY
*Mar 13 21:57:20:                 NSE_PAYLOAD
*Mar 13 21:57:20:                 SIGNAL_TYPE
*Mar 13 21:57:20:                 FAX_BYTES
*Mar 13 21:57:20:                 NTE_TX_PAYLOAD
*Mar 13 21:57:20:                 SEQ_NUM_START
*Mar 13 21:57:20:                 MP_CAP_MODEM_PROTO
*Mar 13 21:57:20:                 MP_CAP_MODEM_CODEC
*Mar 13 21:57:20:                 MP_CAP_VOICE_RTP_NSE_PAYLOAD
*Mar 13 21:57:20:                 MR_INFO
*Mar 13 21:57:20:                 IP_TONE_HANDLER
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:20:                 MODEM_TONE_DET
*Mar 13 21:57:20:                 CM_TONE_DET
*Mar 13 21:57:20:                 PER_CALL_DEBUG
*Mar 13 21:57:20: ISDN Se0/2/0:23 Q931: TX -> SETUP pd = 8  callref =
0x0006
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98397
                Exclusive, Channel 23
        Calling Party Number i = 0x2881, '3014693581'
                Plan:National, Type:National
        Called Party Number i = 0xA1, '13239439922'
                Plan:ISDN, Type:National
*Mar 13 21:57:20: ISDN Se0/2/0:23 Q931: RX <- CALL_PROC pd = 8  callref
= 0x8006

        Channel ID i = 0xA98397
                Exclusive, Channel 23
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:20: Modify Nominator =
*Mar 13 21:57:20:                 DTMF_TONE_DET
*Mar 13 21:57:20:                 FAX_TONE_DET
*Mar 13 21:57:25: ISDN Se0/2/0:23 Q931: RX <- PROGRESS pd = 8  callref =
0x8006
        Progress Ind i = 0x8488 - In-band info or appropriate now
available
*Mar 13 21:57:26: ISDN Se0/2/0:23 Q931: RX <- ALERTING pd = 8  callref =
0x8006
*Mar 13 21:57:27: Modify Nominator =
*Mar 13 21:57:27:                 DTMF_TONE_DET
*Mar 13 21:57:27: Modify Nominator =
*Mar 13 21:57:27:                 DTMF_TONE_DET
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: TX -> DISCONNECT pd = 8  callref
= 0x000
6
        Cause i = 0x8090 - Normal call clearing
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: RX <- RELEASE pd = 8  callref =
0x8006
*Mar 13 21:57:27: ISDN Se0/2/0:23 Q931: TX -> RELEASE_COMP pd = 8
callref = 0x0
006