[cisco-voip] h323 gw config
James Grace
jgrace at digitelusa.net
Tue Mar 28 15:14:35 EST 2006
Trying to config a h323 gw for the first time.
!
voice call send-alert
voice rtp send-recv
!
controller T1 0/0/1
framing esf
linecode b8zs
ds0-group 0 timeslots 9-24 type fxo-ground-start
!
!
interface GigabitEthernet0/0
description uplink to Core SW
ip address 10.2.0.5 255.255.255.0
duplex full
speed 100
h323-gateway voip bind srcaddr 10.2.0.5
!
ip route 0.0.0.0 0.0.0.0 10.2.0.254
!
voice-port 0/0/1:0
output attenuation 0
!
mgcp bind control source-interface GigabitEthernet0/0
mgcp bind media source-interface GigabitEthernet0/0
!
mgcp profile default
!
dial-peer voice 1 pots
description "outbound LD calls"
destination-pattern 9T
incoming called-number .
direct-inward-dial
port 0/0/1:0
so do we need a voip dial peer aswell. And on our CM we are using the 9.@
with discard predot will this work with the below dial peer. Also we have
a T1 with groudstart from the carrier, how do my controller look
James D. Grace
CCNP CCNA MCSE MCDBA
Sr. System Engineer / Professional Svc.
Digitel Corporation
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060328/ee85f47a/attachment.html
More information about the cisco-voip
mailing list