[cisco-voip] h323 gw config
Kevin Thorngren
kthorngr at cisco.com
Tue Mar 28 19:54:39 EST 2006
Did you use the IP Address of 10.2.0.5 for your H.323 GW config in
CCMAdmin?
Here is an example that may help:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/
products_tech_note09186a0080094636.shtml
Kevin
On Mar 28, 2006, at 5:43 PM, James Grace wrote:
> This is what I get
>
>
> DISC CAUSE CODE FROM OTHER PEER FROM H323 PEER
> 3 no route to destinatio 4 0
>
> H323 gateway internal event queue:
> Events queued 0, free 1, held 1, allocated 1 times, exceed max 0
> times
> Max serviced 1, Max serviced exceed 0
> no dest 0, no buffers 0, call flushes 0
>
> CRV statistics
> In use: 0
> Max collisions obtaining crv: 0
>
>
> From: Leetun, Rob [mailto:rleetun at co.boulder.co.us]
> Sent: Tuesday, March 28, 2006 4:59 PM
> To: James Grace
> Subject: RE: [cisco-voip] h323 gw config
>
> That is for four digit dialing inside our network. [1-8]... The last
> three dots are any number that starts with a number 1, 2, 3, 4, 5, 6,
> 7, or 8
>
>
>
> From: James Grace [mailto:jgrace at digitelusa.net]
> Sent: Tuesday, March 28, 2006 2:48 PM
> To: Leetun, Rob
> Subject: RE: [cisco-voip] h323 gw config
> Thank for the help
> The one im confused on is the destination-pattern [1-8] Where or what
> is this for when dealing with cm
>
>
> From: Leetun, Rob [mailto:rleetun at co.boulder.co.us]
> Sent: Tuesday, March 28, 2006 4:42 PM
> To: James Grace
> Subject: RE: [cisco-voip] h323 gw config
>
> Yours could look like this:
>
> dial-peer voice 20 voip
> preference 1 (this says to use this dial peer first and the other
> one second, put your Pub first and the Sub second)
> destination-pattern [1-8]... (You could change this to
> dail preference for your shop)
> progress_ind setup enable 3
> voice-class codec 1
> voice-class h323 1
> session target ipv4:10.2.0.20 (Your CallManager)
> dtmf-relay cisco-rtp h245-signal h245-alphanumeric
> no vad
>
> dial-peer voice 21 voip
> preference 2
> destination-pattern [1-8]... (You could change this to
> dail preference for your shop)
> progress_ind setup enable 3
> voice-class codec 1
> voice-class h323 1
> session target ipv4:10.2.0.21 (Your CallManager)
> dtmf-relay cisco-rtp h245-signal h245-alphanumeric
> no vad
> Does this help?
>
> From: James Grace [mailto:jgrace at digitelusa.net]
> Sent: Tuesday, March 28, 2006 2:27 PM
> To: Leetun, Rob
> Subject: RE: [cisco-voip] h323 gw config
> Im a little confuse on the voip dial peer
> My callmanager is 10.2.0.20 and 21. can you send me a example of a
> good voip dial peer .
>
>
> From: Leetun, Rob [mailto:rleetun at co.boulder.co.us]
> Sent: Tuesday, March 28, 2006 3:41 PM
> To: James Grace
> Subject: RE: [cisco-voip] h323 gw config
>
> Hi James,
>
> Here is the config off one of our gateways. Good Luck
>
> Rob
>
> voice service voip
> modem passthrough nse codec g711ulaw
> !
> !
> voice class codec 1
> codec preference 1 g711ulaw
> codec preference 2 g729r8
> !
> !
> !
> voice class h323 1
> h225 timeout tcp establish 3
> !
> voice-port 1/0:23
> input gain 6
> output attenuation 3
> no vad
> bearer-cap Speech
> !
> voice-port 1/1:23
> input gain 6
> output attenuation 3
> no vad
> bearer-cap Speech
> !
> !
> no mgcp package-capability res-package
> mgcp package-capability sst-package
> no mgcp timer receive-rtcp
> mgcp sdp simple
> mgcp fax t38 inhibit
> mgcp rtp payload-type g726r16 static
> !
> !
> dial-peer cor custom
> !
> !
> !
> dial-peer voice 1 pots
> incoming called-number ....
> direct-inward-dial
> !
> dial-peer voice 10 voip
> preference 1
> destination-pattern [1-8]...
> progress_ind setup enable 3
> voice-class codec 1
> voice-class h323 1
> session target ipv4:192.168.20.2
> dtmf-relay cisco-rtp h245-signal h245-alphanumeric
> no vad
> !
> dial-peer voice 11 voip
> preference 3
> destination-pattern [1-8]...
> progress_ind setup enable 3
> voice-class codec 1
> voice-class h323 1
> session target ipv4:192.168.20.3
> dtmf-relay cisco-rtp h245-signal h245-alphanumeric
> no vad
> !
> dial-peer voice 2 pots
> destination-pattern 9..........
> port 1/0:23
> !
> dial-peer voice 3 pots
> destination-pattern 9...........
> port 1/0:23
> !
> dial-peer voice 911 pots
> destination-pattern 911
> port 1/0:23
> prefix 911
> !
> dial-peer voice 9911 pots
> destination-pattern 9911
> port 1/0:23
> prefix 911
> !
> dial-peer voice 12 voip
> preference 2
> destination-pattern [1-8]...
> progress_ind setup enable 3
> voice-class codec 1
> voice-class h323 1
> session target ipv4:192.168.248.22
> dtmf-relay cisco-rtp h245-signal h245-alphanumeric
> no vad
>
>
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of James Grace
> Sent: Tuesday, March 28, 2006 1:15 PM
> To: cisco-voip at puck.nether.net
> Cc: Scott.Voll at wesd.org
> Subject: [cisco-voip] h323 gw config
>
> Trying to config a h323 gw for the first time.
>
>
>
> !
>
> voice call send-alert
>
> voice rtp send-recv
>
>
>
> !
>
> controller T1 0/0/1
>
> framing esf
>
> linecode b8zs
>
> ds0-group 0 timeslots 9-24 type fxo-ground-start
>
> !
>
> !
>
> interface GigabitEthernet0/0
>
> description uplink to Core SW
>
> ip address 10.2.0.5 255.255.255.0
>
> duplex full
>
> speed 100
>
> h323-gateway voip bind srcaddr 10.2.0.5
>
> !
>
> ip route 0.0.0.0 0.0.0.0 10.2.0.254
>
> !
>
> voice-port 0/0/1:0
>
> output attenuation 0
>
> !
>
> mgcp bind control source-interface GigabitEthernet0/0
>
> mgcp bind media source-interface GigabitEthernet0/0
>
> !
>
> mgcp profile default
>
> !
>
> dial-peer voice 1 pots
>
> description "outbound LD calls"
>
> destination-pattern 9T
>
> incoming called-number .
>
> direct-inward-dial
>
> port 0/0/1:0
>
>
>
>
>
> so do we need a voip dial peer aswell. And on our CM we are using
> the 9.@ with discard predot will this work with the below dial peer.
> Also we have a T1 with groudstart from the carrier, how do my
> controller look
>
>
> James D. Grace
> CCNP CCNA MCSE MCDBA
> Sr. System Engineer / Professional Svc.
> Digitel Corporation
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: text/enriched
Size: 31529 bytes
Desc: not available
Url : https://puck.nether.net/pipermail/cisco-voip/attachments/20060328/107d9e91/attachment-0001.bin
More information about the cisco-voip
mailing list