[cisco-voip] Caller-id name
Andriy A. Yerofyeyev
andriy.yerofyeyev at gmail.com
Mon Oct 30 12:58:43 EST 2006
Hello folks,
Trying to figure out why our AS5350 does not understand Caller ID
name , sent by Telco.
Part of Q931 below:
Progress Ind i = 0x8488 - In-band info or appropriate now available
Oct 30 12:13:52.980: ISDN Se2/0:23 Q931: RX <- SETUP pd = 8 callref =
0x0239
Bearer Capability i = 0x8090A2
Standard = CCITT
Transer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98386
Exclusive, Channel 6
Facility i = 0x9F8B0100A10F02010106072A8648CE1500040A0100
Progress Ind i = 0x8283 - Origination address is non-ISDN
Calling Party Number i = 0x2183, '5165098757'
Plan:ISDN, Type:National
Called Party Number i = 0xA1, '7187323897'
Plan:ISDN, Type:National
Oct 30 12:13:53.008: ISDN Se2/0:23 Q931: TX -> CALL_PROC pd = 8 callref
= 0x8239
Channel ID i = 0xA98386
Exclusive, Channel 6
I assume what Telco sent CNAME as Facility IE , but don't understand why
cisco cannot decode it.
Is there any way to tune Facility IE on Cisco ?
Which standard regulate CNAME over ISDN PRI ?
--
Best regards,
Andriy A. Yerofyeyev.
Senior Network Engineer.
--
IMPROCOM, INC
www : http://www.improcom.com
Phone : 1-718-769-3400
-----------
This message and any attachments are intended only for the use of the
addressee and may contain information that is privileged and
confidential. If the reader of the message is not the intended recipient
or an authorized representative of the intended recipient, you are
hereby notified that any dissemination of this communication is strictly
prohibited. If you have received this communication in error, please
notify us immediately by e-mail and delete the message and any
attachments from your system.
More information about the cisco-voip
mailing list