[cisco-voip] Caller-id name
Wes Sisk
wsisk at cisco.com
Mon Oct 30 13:59:46 EST 2006
cname over isnd pri is discussed in primary-ni version 3
specifification. it's very similar to name encoding in qsig.
GR-1367-CORE
SR-4994
CM will not receive/decode this over h323 interface.
/Wes
Andriy A. Yerofyeyev wrote:
> Hello folks,
>
> Trying to figure out why our AS5350 does not understand Caller ID
> name , sent by Telco.
>
> Part of Q931 below:
>
> Progress Ind i = 0x8488 - In-band info or appropriate now available
> Oct 30 12:13:52.980: ISDN Se2/0:23 Q931: RX <- SETUP pd = 8 callref =
> 0x0239
> Bearer Capability i = 0x8090A2
> Standard = CCITT
> Transer Capability = Speech
> Transfer Mode = Circuit
> Transfer Rate = 64 kbit/s
> Channel ID i = 0xA98386
> Exclusive, Channel 6
> Facility i = 0x9F8B0100A10F02010106072A8648CE1500040A0100
> Progress Ind i = 0x8283 - Origination address is non-ISDN
> Calling Party Number i = 0x2183, '5165098757'
> Plan:ISDN, Type:National
> Called Party Number i = 0xA1, '7187323897'
> Plan:ISDN, Type:National
> Oct 30 12:13:53.008: ISDN Se2/0:23 Q931: TX -> CALL_PROC pd = 8 callref
> = 0x8239
> Channel ID i = 0xA98386
> Exclusive, Channel 6
>
> I assume what Telco sent CNAME as Facility IE , but don't understand why
> cisco cannot decode it.
> Is there any way to tune Facility IE on Cisco ?
> Which standard regulate CNAME over ISDN PRI ?
>
>
>
More information about the cisco-voip
mailing list