[cisco-voip] Intl Calls with Verizon in Philadelphia area

[CarlosOrtiz at bayviewfinancial.com]

Here is a test call :

ug 31 11:04:48.367 EDT: ISDN Se0/1/0:23 Q931: pak_private_number: Invalid 
type/plan 0x0 0x0 may be overriden; sw-type 13
Aug 31 11:04:48.367 EDT: ISDN Se0/1/0:23 Q931: pak_private_number: Invalid 
type/plan 0x0 0x0 may be overriden; sw-type 13
Aug 31 11:04:48.371 EDT: ISDN Se0/1/0:23 Q931: Applying typeplan for 
sw-type 0xD is 0x1 0x1, Called num 011448458787000
Aug 31 11:04:48.371 EDT: ISDN Se0/1/0:23 Q931: TX -> SETUP pd = 8  callref 
= 0x0243 
        Bearer Capability i = 0x8090A2 
                Standard = CCITT 
                Transfer Capability = Speech 
                Transfer Mode = Circuit 
                Transfer Rate = 64 kbit/s 
        Channel ID i = 0xA98393 
                Exclusive, Channel 19 
        Progress Ind i = 0x8183 - Origination address is non-ISDN 
        Calling Party Number i = 0x2181, '2156641300' 
                Plan:ISDN, Type:National 
        Called Party Number i = 0x91, '011448458787000' 
                Plan:ISDN, Type:International
Aug 31 11:04:48.467 EDT: ISDN Se0/1/0:23 Q931: RX <- CALL_PROC pd = 8 
callref = 0x8243 
        Channel ID i = 0xA98393 
                Exclusive, Channel 19
Aug 31 11:04:48.583 EDT: ISDN Se0/1/0:23 Q931: RX <- PROGRESS pd = 8 
callref = 0x8243 
        Cause i = 0xC484 - Vacant code or prefix digit not dialed 
        Progress Ind i = 0x8288 - In-band info or appropriate now 
available 
Aug 31 11:04:50.855 EDT: ISDN Se0/2/0:23 Q931: Ux_DLRelInd: DL_REL_IND 
received from L2







"Brian E. Henry" <bhenry33 at adelphia.net> 
08/31/2007 09:56 AM
Please respond to
bhenry33 at adelphia.net


To
CarlosOrtiz at bayviewfinancial.com
cc
cisco-voip at puck.nether.net
Subject
Re: [cisco-voip] Intl Calls with Verizon in Philadelphia area






What is the cause code that you receive back from the telco?

I have used translation rules in the past on H323 gateways to do what you 
were doing and I do believe that 44 is United Kingdom and found that the 
provider was prefixing 011 also and thus the call failing.  I just sent 
them, for United Kingdom calls, 44XXXXX and it worked just fine.

Brian
---- CarlosOrtiz at bayviewfinancial.com wrote: 
> I am not able to send International calls through our PRI's at a 
location 
> outside of Philly.  Local and LD work fine.  debugs at the router show 
the 
> number being sent to the telco are fine. 
> 
> Debug ISDN q931
> 
> Calling Party Number i = 0x2181, '215664XXXX' 
>                 Plan:ISDN, Type:National 
>         Called Party Number i = 0x91, '011448458787000'
> 
> I found a CCO TAC case where this exact problem is described and 
addressed 
> by changing the calling plan type from national to unknown using the 
> following command under the D channel interface.
> 
> isdn map address .* plan isdn type unknown
> 
> This did in fact change the plan type but I was unable to complete 
local, 
> LD and Intl after adding this.
> 
> Any suggestions?
> 
> Carlos
> 
> 
> 
> 
> 
> 
> 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070831/708695ee/attachment.html