[cisco-voip] call translation patterns

[Ryan Ratliff]

Unless you can sneak translations in an h323 class there is no  
translation being done on that dial-peer.

Look for dial-peers with some form of the word 'translate' in them.

-Ryan

On Aug 18, 2008, at 11:30 AM, Matthew Loraditch wrote:

All,

I’ve inherited a system where all of the translation was done at the  
voice routers instead of in CCM. I’m not a big fan of that and would  
like to move all my patterns to the server.

Below is the current config on one of the dial peers, what do I need  
to do to remove translation from the router? I know it has to do with  
changing the destination pattern, but I’m not sure if ijust remove  
the line or change it somehow.





dial-peer voice 100 voip

  tone ringback alert-no-PI

  description FOR INBOUND 443-xxx-xxxx Calls to CCMP

  preference 1

  destination-pattern 4431234...

  progress_ind setup enable 3

  progress_ind progress enable 8

  progress_ind connect enable 8

  voice-class codec 1

  voice-class h323 1

  session target ipv4:XX.XX.XX.XX

  incoming called-number .

  dtmf-relay rtp-nte h245-signal h245-alphanumeric

  no vad



Thanks for the help!



Matthew Loraditch
10944 Beaver Dam Road, Suite A
Hunt Valley, Maryland  21030
support at heliontechnologies.com
(p) (410) 252-8830
(F) (443) 541-1593

Visit us at www.heliontechnologies.com
Support Issue? Email support at heliontechnologies.com for fast assistance!



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080818/984caa0d/attachment.html>