[cisco-voip] call translation patterns

[Joe Cisco]

This dial peer is not translating anything. It simply says if an
inbound call is bound for any 10 digit extension that begins with
"4431234" send it as an h323 call to the device that has the IP listed
in the session target line.

-Joe C.

On Mon, Aug 18, 2008 at 10:30 AM, Matthew Loraditch
<MLoraditch at heliontechnologies.com> wrote:
> All,
>
> I've inherited a system where all of the translation was done at the voice
> routers instead of in CCM. I'm not a big fan of that and would like to move
> all my patterns to the server.
>
> Below is the current config on one of the dial peers, what do I need to do
> to remove translation from the router? I know it has to do with changing the
> destination pattern, but I'm not sure if ijust remove the line or change it
> somehow.
>
>
>
>
>
> dial-peer voice 100 voip
>
>  tone ringback alert-no-PI
>
>  description FOR INBOUND 443-xxx-xxxx Calls to CCMP
>
>  preference 1
>
>  destination-pattern 4431234...
>
>  progress_ind setup enable 3
>
>  progress_ind progress enable 8
>
>  progress_ind connect enable 8
>
>  voice-class codec 1
>
>  voice-class h323 1
>
>  session target ipv4:XX.XX.XX.XX
>
>  incoming called-number .
>
>  dtmf-relay rtp-nte h245-signal h245-alphanumeric
>
>  no vad
>
>
>
> Thanks for the help!
>
>
>
> Matthew Loraditch
> 10944 Beaver Dam Road, Suite A
> Hunt Valley, Maryland  21030
> support at heliontechnologies.com
> (p) (410) 252-8830
> (F) (443) 541-1593
>
> Visit us at www.heliontechnologies.com
> Support Issue? Email support at heliontechnologies.com for fast assistance!
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>