[cisco-voip] VWIC2-2MFT-T1 Voice/Data Clocking

[Turpin, Mark]

I take it the two circuits are connected to two different systems?

 

Pretty sure you need to set one to be internal and one line.  Of course
you'll want to sync this change with your provider(s).

 

--

MARK TURPIN  |  Systems Engineer  |  CCIE 21649 (Voice)  |  Calence /
Insight Networking Solutions  | www.calence.com  

t. 314.656.2315   c. 314.660.5800   f. 314.656.2355
mark.turpin at calence.com

 

The information contained in this message and any attachment may contain
privileged or confidential information protected from disclosure. If you
are not the intended recipient, or an employee or agent responsible for
delivering this message to the intended recipient, you are hereby
notified that any review, dissemination, distribution or copying of this
information is strictly prohibited.  If you have received this
transmission in error, please notify the sender immediately by replying
to this message and destroying the original and all copies.  Thank you.

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Carter, Bill
Sent: Friday, August 22, 2008 2:46 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] VWIC2-2MFT-T1 Voice/Data Clocking

 

Any solution... VWIC2-2MFT-T1, port 0 Data T1, port 1 Voice PRI. Getting
lots of slips and CRC errors 0/0/0 data t1 port.

 

I have

network-clock-participate wic 0

network-clock-select 1 t1 0/1/0

 

controller T1 0/0/0
framing esf
linecode b8zs

clock source line
channel-group 1 timeslots 1-24
!
controller T1 0/1/0
framing esf
linecode b8zs

clock source line
pri-group timeslots 1-24

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080822/20818ee4/attachment-0001.html>