[cisco-voip] CME with PolyCom VSX7000

[Ramiz Sardar]

Hi,
Thanks for you reply.... I have only one router in network that is working
as CME/CUE so should i configure that router as gatekeeper. And will it
require more dsp resources ? I need your further support regarding this so
please guide me the right way.

Best Regards


On 8/28/08, Philip Walenta <pwalenta at wi.rr.com> wrote:
>
>  A few things here to help you out:
>
> 1.  In order to use video on thet PRI it must have a separate set of dial
> peers that define video.
> 2. It can't be registered directly to CME yet (I work for Polycom and I'm
> working on getting our SCCP build functional with CME).
> 3. You can setup a gatekeeper on that CME system and register both the CME
> and the VSX to that gatekeeper with an extension within your dial plan.
> 4.  SIP is not officially supported but it might work. This may change in
> the future.
>
>  ------------------------------
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Ramiz Sardar
> *Sent:* Thursday, August 28, 2008 1:56 AM
> *To:* cisco-voip
> *Subject:* [cisco-voip] CME with PolyCom VSX7000
>
>
>  Hi Friends,
>
> I have IP Telephony setup in my office that include Cisco 2811 as CME and
> voice gateway with PSTN through E1 PRI. Now i want to integrate Polycom
> VSX7000 video conferencing device with IP Telephony network so that i would
> assign extension on this device and it could use the same PRI for video
> calls. There are two or three ideas in my mind like registering it with CME
> or through SIP / H323 or configure router as gateway but i don't know how i
> will do that. If someone has idea about it, please help me out and if any
> good doc. available then share with me.
>
> Waiting for positive quick response.
>
> Best Regards
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080830/66893da1/attachment-0001.html>