[cisco-voip] FXS and DSP

[Joe Cisco]

Typically just leave the complexity the default unless you have a reason to
change it. It would only affect conference resources if you built hardware
conference resources on the router in question (or transcoder resources) and
then put them in a MRG in callmanager.

-Joe C.

On Thu, Jun 5, 2008 at 9:06 AM, David Lima <David.Lima at alphasys.com.bo>
wrote:

>  Thanks guys for the information,  it is clear now,  I'm reading about
> this right now, but i can't figure out when I should use High-complexity
> codec or Medium.complexity codec if I have 8 FXO ports. This selection can
> affect the conferences that I made?
>
>
>
> Thansk again
>
>
>
> David
>  ------------------------------
>
> *De:* Voice Noob [mailto:voicenoob at gmail.com]
> *Enviado el:* jueves, 05 de junio de 2008 Ue v8.5 08:45
> *Para:* David Lima
> *CC:* Joe Cisco; cisco-voip at puck.nether.net
>
> *Asunto:* Re: [cisco-voip] FXS and DSP
>
>
>
> Also a PVDM2-8 is half of a dsp. The PVDM2-16 is 1 DSP.
>
> On Wed, Jun 4, 2008 at 10:13 PM, David Lima <David.Lima at alphasys.com.bo>
> wrote:
>
> Thanks a lot for the link man, but according with the DSP Calculator, this
> relationship is correct?
>
>                               1 PVDM2-8 (1 DSP) has 8 voice channel to
> g711.
>                               1 FXS/FXO port needs two voice channel (1 for
> TX and the other 1 for RX)
>                               then
>                               1 PVDM2-8 can support 1 VIC2-4FXS
>
> Thanks for your answer
> David
> ________________________________________
> De: Joe Cisco [smetsysocsic at gmail.com]
> Enviado el: miércoles, 04 de junio de 2008 04:54 p.m.
> Para: David Lima
> CC: cisco-voip at puck.nether.net
> Asunto: Re: [cisco-voip] FXS and DSP
>
>
> Cisco DSP Calculator:
>
> http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl
>
> -Joe C.
>
> On Wed, Jun 4, 2008 at 3:42 PM, David Lima <David.Lima at alphasys.com.bo
> <mailto:David.Lima at alphasys.com.bo>> wrote:
> Hi guys, I need to install two VIC2-4FXS ports in a router Cisco  2801,
> could any one told me how to calculate the necessary DSP?
>
> David
>
> _______________________________________________
> cisco-voip mailing list
>
> cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
>
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080605/6fdb9a0d/attachment.html>