[cisco-voip] MWI Issue

[Wes Sisk]

Hi Scott,

What is complete CM version? We had this in 4.x and I see a similar for 
6.0, but fixed in 6.1(1.1000.11).

/Wes

Scott Coner (US) wrote:
>
> Anyone seen an issue with MWI for unregistered devices in CM 6.1?  
> Configuration is CM 6.1 connected to Avaya PBX through Qsig trunk and 
> using Avaya VM for the IP phones.  If a VM is left for an unregistered 
> IP communicator there is no MWI set on the device the next time the 
> user registers.  We tried this with a physical phone also, if a VM is 
> left while a physical phone is unregistered there is no MWI when it 
> registers again.  If the devices are registered at the time the VM is 
> left then MWI functions properly.
>
>  
>
> Thanks,
>
>  
>
> Scott
>
>  
>
>  
>
> ------------------------------------------------------------------------
>
> *Disclaimer: This e-mail communication and any attachments may contain 
> confidential and privileged information and is for use by the 
> designated addressee(s) named above only. If you are not the intended 
> addressee, you are hereby notified that you have received this 
> communication in error and that any use or reproduction of this email 
> or its contents is strictly prohibited and may be unlawful. If you 
> have received this communication in error, please notify us 
> immediately by replying to this message and deleting it from your 
> computer. Thank you. *
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080617/e7b022c3/attachment.html>