[cisco-voip] MWI Issue

[Jay Pearson]

Hey there,

 

 If I am not mistaken, MWI are sent only at the time the message is left.
The VM system sends the MWI and never "checks" later to see if the phone
received the MWI at all. Not sure how Octel/Avaya system perform MWI, but I
think this is the way Cisco's Unity works. Not tried it though. 

 

 

 

 

Jay Pearson

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Scott Coner (US)
Sent: Monday, June 16, 2008 16:13
To: cisco-voip at puck-nether.net
Subject: [cisco-voip] MWI Issue

 

Anyone seen an issue with MWI for unregistered devices in CM 6.1?
Configuration is CM 6.1 connected to Avaya PBX through Qsig trunk and using
Avaya VM for the IP phones.  If a VM is left for an unregistered IP
communicator there is no MWI set on the device the next time the user
registers.  We tried this with a physical phone also, if a VM is left while
a physical phone is unregistered there is no MWI when it registers again.
If the devices are registered at the time the VM is left then MWI functions
properly.

 

Thanks,

 

Scott

 

 

  _____  

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee, you
are hereby notified that you have received this communication in error and
that any use or reproduction of this email or its contents is strictly
prohibited and may be unlawful. If you have received this communication in
error, please notify us immediately by replying to this message and deleting
it from your computer. Thank you. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20080616/2d412e02/attachment.html>