[cisco-voip] silent monitor with out a CAD

[Peter Slow]

David,
   If you wanted to do something awful that would make you re-examine
your QoS strategy and increase the complexity of your network, you
could get around what Scott (who is correct) said by placing an MTP at
the site where the IPCCx server is located, and forcing your voice
traffic through that.
  You could use this to avoid needing to SPAN over the WAN. Whether or
not this solution is feasible depends on your network architecture and
where gateways, servers etc. are located.

-Peter

On 6/20/08, Scott Voll <svoll.voip at gmail.com> wrote:
> Since your saying without CAD they must be agents?  if so, you have to setup
> a SPAN back to the other nic on the IPCCx server.  layer 3 will be an issue
> as RSPAN can't go across layer 3 wans.  unless you can RSPAN around the
> layer 3 link you are correct.
>
> Scott
>
>
> On Fri, Jun 20, 2008 at 10:20 AM, David Toledo <DavidT at morganmint.com>
> wrote:
> >
> >
> >
> >
> >
> > Hi
> >
> >
> >
> > I'm trying to figure it out how to silent monitor an IPhone with out a
> CAD.
> >
> > What will my requirements? Someone said it cannot be done over layer 3 is
> that true?
> >
> >
> >
> > This is my setup
> >
> >
> >
> > 1-       pstn
> >
> > 2-       gateway 2851
> >
> > 3-       Switch 3560
> >
> > 4-       4- phones
> >
> >
> >
> >
> >
> > Can some help me please to understand to make this works
> >
> >
> >
> > Thanks
> >
> >
> >
> > David
> >
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> >
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>