[cisco-voip] No Caller ID on 1760 FXO with CME4.1
Chris Cope
chris.cope at wirelessinitiatives.co.uk
Wed Jun 25 11:41:48 EDT 2008
Hi,
The hardware is as follows (VIC-2FXO=):
VIC Slot 3:
Dual FXO Voice Interface Card
Hardware revision 1.1 Board revision C0
Serial number 0008836240 Part number 800-02495-01
FRU Part Number VIC-2FXO=
Test history 0x00 RMA number 00-00-00
Connector type WAN Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 0D 01 01 00 86 D4 90 50 09 BF 01 00 00 00 00
0x30: 60 00 00 00 98 05 23 01 FF FF FF FF FF FF FF FF
When in interface config mode on voice-port 3/0 it does not allow any
caller-id commands.
Some of the Cisco documentation implies that this is not supported on
anything below a 2610 (see ..
http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dt_clid.h
tml )
Chris
More information about the cisco-voip
mailing list