[cisco-voip] No Caller ID on 1760 FXO with CME4.1

[Matt Slaga (US)]

This card does not support caller-id.

-----Original Message-----
From: Chris Cope [mailto:chris.cope at wirelessinitiatives.co.uk] 
Sent: Wednesday, June 25, 2008 11:42 AM
To: Matt Slaga (US); Turpin, Mark; cisco-voip at puck-nether.net
Subject: RE: [cisco-voip] No Caller ID on 1760 FXO with CME4.1

Hi,

The hardware is as follows (VIC-2FXO=):

VIC Slot 3:
Dual FXO Voice Interface Card
Hardware revision 1.1   Board revision C0
Serial number     0008836240    Part number    800-02495-01
FRU Part Number   VIC-2FXO=

Test history      0x00          RMA number     00-00-00
Connector type    WAN Module
EEPROM format version 1
EEPROM contents (hex):
0x20:   01 0D 01 01 00 86 D4 90 50 09 BF 01 00 00 00 00
0x30:   60 00 00 00 98 05 23 01 FF FF FF FF FF FF FF FF


When in interface config mode on voice-port 3/0 it does not allow any
caller-id commands.

Some of the Cisco documentation implies that this is not supported on
anything below a 2610 (see ..
http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dt_clid.h
tml )

Chris 

-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.